LOAD ASSIST APPLICATION: 4WD, UTE, TRADESMAN

Probag load assist kits allow adjustment for loads and road conditions by increasing or decreasing pressure in the airsprings.

• Increase vehicle stability
• Prevent bottoming out
• Reduce tyre wear
• Improve steering and balance

*Probag Load Assist / Tow Kits, designed & built in Australia for our tough conditions. Probag load assist airbags can support up to 2200kg of weight depending on the rated capacity of your vehicle. Bags have a 490psi burst pressure.

*NOTE: OUR BAGS HAVE A 490psi BURST PRESSURE RATING

*12 months / 20,00km limited warranty. All kits come with neccessary hardware, hoses & valves.

*Don't see your vehicle? call us and we can build one for you.

*All items and prices subject to change without notice - all prices include gst.

Dimensions

330(L) 220(H) 140(w)

BIG PRO Compressor (PX7) 12v 100% duty, restart amp draw of 30amps max pressure 200psi recommended running pressure of 0 to 150psi continuous, will restart at 200psi. External washable air filter for easy maintenance, fan on rear of engine for cooling. Robust construction, replacement parts available for re-build (if needed). No lubrication required, pumps about 3.5cfm free flow. Out performs most other compressors.

• Low voltage supply causes amp spikes, which can damage your compressors motor.

• Always use a pressure switch that will shut off the compressor at or before its maximum working pressure. Never use adjustable pressure switches, they will allow your compressor to exceed it's maximum working pressure.

• Make sure that your engine is running while you are running your air compressors, to ensure your air compressors are getting enough supply voltage.

• Compressors should be mounted as close as possible to the battery to keep the positive wire as short as possible and amp draw to a minimum.
Safety valve pop-off valve pressure should be at 25psi higher than the cut off pressure of your pressure switch. Safety valves will begin to bleed at up to 15psi below safety valves rated pressure.

• Always operate compressors below the maximum pressure rating of the compressor according to each compressors specifications.

• Choose a compressor mounting location that is cool as possible and away from heat sources. This will help the compressor run cooler and last longer.
Always install compressors higher than the air reservoir tanks intake port to keep moisture from leaking into the compressor's head.

2 Gallon deep draw short stubbie air tank 130mm (h)
Suitable for small air requiements !/4" npt outlets
ie: (difflocks etc)